MENU
products
  1. Home
  2. --
  3. Industrial boilers

permissible sulphur levels in electrostatic precipitators for coal fired boiler

Product Thermal Capacity: 1 - 20 t/h

Working Pressure: 0.7 - 2 Mpa

Available Fuel: Nature gas, coke oven gas, biogas, methanol, liquid propane gas, diesel, heavy oil, light oil, crude oil, etc.

Available Industries: Heat supplying, chemical, food, textile, printing and dyeing, cigarettes and tobacco, fodder, pharmacy, building materials, brewery, rubber, hospital etc.

Get a Quote Send Message

Introduction of WNS gas / oil fired steam boiler:

WNS series horizontal internal combustion boiler is a boiler shell type 3 passes wetback oil/gas fired boiler. After fuel is being atomized by burner, flame is full of the wave furnace and transfer heat via furnace wall, this is 1st pass; the high temperature smoke is collected in reversal chamber and then enters 2nd pass which is grooved tubes bundle area; after heat convection, air temperature gradually falls and goes to front smoke box and turn to 3rd pass, which is smooth tubes bundle area, and then enters chimney passing back smoke box and exhausted to the atmosphere.

Technical advantages:

1. Digitized manufacture
The key part such as material cutting, rolling, drilling are proceeded by advanced CNC machining process to reduce the assemble stress and extend boiler working lifetime.
The front and back smoke chamber plates are cut by CNC plasma cutting machine and looks tidy and beautiful.

2.Easy operation and maintenance
Fully automatically operating, with automatically adjustment and protection of burning, water level, temperature and steam pressure.

3. Longer working life
Smoke tube and tube sheet connection is expanded first to eliminate the gap between them, then adopt automatic argon arc welding to relief the stress and expand boilers working life.
Longitudinal and girth joint adopt advanced automatic submerged-arc welding for good welding quality. All longitudinal and girth joint will have 100% radiographic inspection.
Fin tube us ND steel or stainless-steel material which avoid low temperature corrosion.
Inspection procedure point is set up to guarantee the sequence of expanding and welding, avoid cracking of the tube sheet holes.

4. Less fuel consumption
High quality aluminum silicate fiber is used with fire clay insulation, to control the boiler body temperature below 45℃ to control heat lost.
Sufficient steam storage room and heating area makes boiler to generate high quality steam and high thermal power.
Condenser is added to reuse the waste heat of the exhausted smoke to increase feeding water’s temperature and reduce emission temperature, which can increase the thermal efficiency above 98% and save operating cost.

Electrostatic Precipitator Costs for Large Coal-Fir

----- 1.0 INTRODUCTION The purposes of this task are: 1) To determine the costs for electrostatic precipita- tors to control particulate emissions from large coal-fired steam generators, such costs to be a function of different coal types, boiler sizes, and emission limits; 2) To identify the total costs that will result from the addition of electrostatic precipitators to the proposed new

Factors Affecting the Resistivity of Recovery Boil

Electrostatic precipitators (ESPs) are common devices used to remove particulates from combustion gases. They are used in coal fired power plants, cement plants, steel mills, and waste incineration plants. In the kraft recovery process, ESPs are used to control emissions of dust formed from the combustion of black liquor in the recovery boiler.

Electrostatic Precipitator - an overview | ScienceDire

Electrostatic precipitator. An ESP uses an electrical charge to separate the particles in the flue gas stream under the influence of an electric field. More than 70% of existing coal-fired power plants are reported to have installed ESPs. In brief, an ESP works by imparting a positive or negative charge to particles in the flue gas stream.

CONDITIONS FOR ELECTROSTATIC PRECIPITATORS AFTER

Conditions for Electrostatic Precipitators after Biomass Fired Boilers re-circulated to keep the content of solid material constant. The bed material is a mixture of inert material (sand) and fuel. Limestone or dolomite is used as bed material for sulphur removal, if the fuel has a high sulphur content.

Sizing and Costing of Electrostatic Precipitato

cold-side ESPs for coal-fired boiler ap-plications. The magnitude of the con-version is very site-specific, but most projects will contain the following ele-ments: • Relocating the air preheater and the ducting to it • Resizing the ESP inlet and outlet duct to the new air volume and re …

Current measurement - electrostatic precipitator - co

In a coal-fired power plant, using the force of an induced electrostatic charge, an electrostatic precipitator (ESP) is used to remove ash, dust and smoke from flue gas so it does not pass into the atmosphere. Accurate measurements of the primary electrostatic transformer current are …

Electrostatic Precipitators - Forbes Marsha

Electrostatic Precipitators (ESPs) are relatively large, low velocity dust collection devices. ESPs remove particles similar to that of static electricity in cloth picking up small pieces of lint. Here the Transformers are used to create extremely high voltage drops between charging and collecting electrode plates generating the electrical field.

Electrostatic precipitators (ESP) | IEA Clean Coal Cent

Jan 20, 2018· Conditioning the fly ash in the flue gas is an established technique used to restore the performance of an ESP in coal-fired power plants with high-resistivity fly ash resulting from burning low sulphur coals. Elemental sulphur, ammonia (NH3), and sulphur trioxide (SO3) are the main conditioning agents currently used. Removal efficiency >99->99.99%

for Electrostatic Precipitato

performances of a thermal plant, fired with coal or other fuels. It evaluates the performances of the electrostatic precipitators, once the operating conditions of the plant are given. This evaluation is based on physical models of the combustion conditions and of the electrostatic precipitation processes.

Electrostatic precipitator - Wikiped

An electrostatic precipitator (ESP) is a filtration device that removes fine particles, like dust and smoke, from a flowing gas using the force of an induced electrostatic charge minimally impeding the flow of gases through the unit.. In contrast to wet scrubbers, which apply energy directly to the flowing fluid medium, an ESP applies energy only to the particulate matter being collected and

ELECTROSTATIC PRECIPITATOR PERFORMANCE IN INDI

Organic sulphur in coal mainly improves thes ash resistivity through SO Electrostatic precipitators can achieve over 99% cleaning efficiency (White 1963). However, The resistivity of the flue gas borne ash in coal fired boilers generally varies from 104 – 1014

Contact Us

zhulin@zozen.com

No. 76, Xin Da Road, Zhou tie Town, Yixing, Wuxi, China

0086-510-68530066, +86-13506151292

Get Latest Price
Get in Touch

If you have any problems about our product and service,please feel free to give your inquiry in the form below. We will reply you within 24 hours as soon as possible.Thank you!

  • Boiler type
  • Name
  • email
  • Phone or Whatsapp
  • message
I accept the Data Protection Declaration

Copyright © 2020.Zhongzheng Boiler Co., ltd. All rights reserved.

top